MTX7R Spec.

1/10 Scale Nitro 4WD Touring Car MTX7R

T2006 MTX7R chassis kit

Mugen Seiki is excited to announce the NEW MTX7R 1/10th nitro touring car kit. The MTX7R kit has new front and rear suspension geometry with longer arms to reduce the unexpected behavior and make the vehicle more predictable. The front arms are 1mm longer and the rear arms are 4.5mm longer, and the front/rear wheel offset has been optimized.

MTX7R new parts:

-	T2160 Rear Lower Bulkhead
-	T2161-21 Rear Anti-Roll Bar Φ2.1 (Optional: T2161-20 Φ2.0/T2161-22 Φ2.2/T2161-23 Φ2.3)
-	T2246 Axle Shaft
-	T2247 Al. Wheel Hub (5mm)
-	T2415 Chassis MTX7R

Technical Data:

-	Length:	380mm
-	Width:	Max. 200mm adjustable
-	Wheel Base:	257.5mm~260.5mm adjustable
-	Tread (F/R):	173mm/169mm
-	F. Caster Angle:	6.4°~13.8° adjustable
-	Gear Ratio:	1st. 7.24:1 / 2nd. 4.69:1

Download:

♦ Parts List 1.82MB
♦ Kit bag details 3.29MB
♦ Setup Sheet 1.58MB
♦ Instruction Manual 11.0MB
♦ Additional instruction Manual 944KB
♦ Optional parts
♦ Other optional parts 4.78MB

Other necessary equipment:

2ch Radio and 2 servos / Receiver / Connecting Cable (aprx.150mm) / Receiver Battery / 12 Class Rear Exhaust Engine / Muffler / Manifold / Manifold Spring / Tire & Wheel / Air Filter / Engine Starter / Body / Body paint tools / Fuel

*	The contents are subject to change without notice due to product improvements and
	specification changes.
*	Final production version of product may and will differ from appearance of product shown
	on this web page.